Jump to content

Squamish Grand Wall - Upper Black Dyke


Recommended Posts

In Squamish, a number of climbs (e.g., The Grand Wall, Europa, Millenium Falcon) reach Bellygood Ledge, two-thirds the way up the Grand Wall proper. Anticlimactically, most people walk off from there, as the wall above is steep and lacking a suitable route... until now.

 

see videos and photos, and download a route topo

 

Over the winter of 2008-2009, Kelly Franz, Seth Adams, Katy Holm, Jacqui Hudson, and I (Jeremy Frimer) retro-ed the Upper Black Dyke. Next time you get to Bellygood, you're not done yet. The summit rim lies within reach!

 

Sean Easton had spearheaded retro work on the route in 1998. Our retro updated his work by (a) releasing loose rock (including about 20 blocks the size of a small fridge) on pitches 1, 3, and 4; (b) cleaning and bolting the dyke itself on pitch 2. Sean's pitch 2 leaves the dyke out right and climbs an unlikely set of thin features for a classic, albeit runout 5.10c pitch. The on-dyke pitch 2 is juggy and about 5.9 with well-protected cruxes; and © cleaning up Bellygood Ledge (cutting branches, tossing loose rock throughout) to avoid future accidents from falling rock.

 

The climbing on the dyke is unusual for Squamish in several ways.

- First, it's juggy. Given that the rock is basalt and not granite, it has very different features: namely jugs everywhere.

- Second, it has short, well-protected cruxes with somewhat run-out rambling (usually in the 5.6 range) in between.

- Third, while we did our best to remove all the loose rock, the nature of the stone means that some loose rock is a permanent feature of the route. Given that Exasperator is directly below, climbers are asked to climb with caution.

 

----------------

 

Upper Black Dyke - 4p, 5.10b (all grades require reconfirmation). Bring a single set of cams, and draws.

 

From Bellygood Ledge, find the dyke.

 

p1. Climb up then left to a steepening wall. Gain the top of the wall to find a bolted belay on the right (35m, 6 bolts, 5.10a/b?)

 

p2. Move up the right edge of the dyke. At the second bolt, the route diverges. For the standard route, move up and left to stay on the dyke (45m, 9 bolts, 5.9?). For the bold, 5.10c variation, launch right onto a quartzite dyke. Belay (bolts) below a roof, to the right of the dyke.

 

p3. Pull over the roof (crux) to gain a ledge. Ramble up and left to skirt an overlap, then wander back right to skirt another. Gain a belay ledge with a bolted belay below a tree on the left. (40m, 7 bolts, 5.10b?)

 

p4. Ramble up the left side of the dyke before pulling through a tricky overlap (crux) just before gaining the summit rim. (30m, 5 bolts, 5.10b?)

 

The climbing on P1 and P2 is a bit gritty at the moment. But a little rain and wind should wash away all the dust.

 

see videos and photos, and download a route topo

 

Link to comment
Share on other sites

  • Replies 10
  • Created
  • Last Reply

Top Posters In This Topic

Nice work!

 

I remember finishing up that thing after the Grand years ago, and thinking 'twas kinda spicy for a bolt-clipping finish--thanks for removing some of the abundant loose rock.

 

Particularly memorable was during that harder stretch of relatively steep face climbing well above a bolt on p. 2, happened upon 2 falcons perched, just blinking at me. (There were no falcons expected at the time, no closure, etc.) The only way to go was between them, but they peeled off when i drew within 5 feet of 'em. Pretty cool but a bit concerning--if they had wanted to mess with me, would've been a long ride...

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...